Delta NC300 contoller setup master slave
Hello
tried to search for some threads on Delta CNC solutions: Delta NC300 controller with ASD-A2 drives and motors (750W) but in vain.
We tried to setup the 4 axis, drives and motor work, but as the Delta manuals (for controller and drives) are so thin, could not find a way to set the master/slave parameters and make it work.
Not sure if anyone familiar with the controller, but worth trying to see if anyone has an idea on how it works.
So in the NC the axes are defined, and parameters for the A axis slave to Y axis is set. Still, the when moving Y, A motor does not move. When tryi ng to move A, it works.
No error is popping up.
I tried to contact Delta customer service but in vain.
I assume the controller adopts standard setup. So suggestions on how other c0ntrollers are set might work.
here the link to NC300 controller manual.
http://www.deltaww.com/filecenter/Pr...N_20160309.pdf
Any input appreciated.
Marius
Re: Delta NC300 contoller setup master slave
SOLVED
the firmware was too old, and update solved the issue instantly
Re: Delta NC300 contoller setup master slave
Quote:
Originally Posted by
ananayas
Hello dear I have the same control and I have some problems has the firmware and if you can give it to me, I would appreciate it.
did you solved it?
Re: Delta NC300 contoller setup master slave
Quote:
Originally Posted by
nicubila
did you solved it?
I have not been able to fix it. Can you please send the firmware and information to me at [email protected]. I would appreciate it very much
1 Attachment(s)
Re: Delta NC300 contoller setup master slave
Hi,
only now I managed to get the file, hope this is the one.I cannot upload it as original *.pkf, so you have to change the extension.
this is the instructions i received. But because it is 2 years ago when it was installed by someone else on my nc300, i cannot say if this is really how it works.
Marius
ps: I managed to make work the homing for absolute encoders in case you need it. it is a simple file, few lines
