Fanuc Oi Mate-TB : 1006

CNC had a hydraulic leak, from a seal between the Turret and Spindle. Gearbox was stripped, cam was removed to replace the seal, on assembly the sensor timing went off. I did have 1007 - Turret Counter Error, which I resolved.
Symptoms : Turret not locking
Error : 1006
What are the significance of the red lights at the rear of the turret ?
- Position 1 (3 red lights) , Position 4 (1 red ) , Position 5 (2 red ) , Position 7 (2 red) , Position 9 (2 red) , Position 10 (1 red)
Please help me with this.
Unable to upload the video, click the Google Drive link for the file.

https://drive.google.com/file/d/12a9cNjYByVqAbsGOTSLBbZYvLEVlRfqN/view?usp=drive_link

Note the Google Drive video link doesn't work for me due to a 'permissions' issue. IMO its likely others will also see a similar message. YouTube may be a better choice.

- - - Updated - - -

Note the Google Drive video link doesn't work for me due to a 'permissions' issue. IMO its likely others will also see a similar message. YouTube may be a better choice.

Thank you for informing me, here is the Youtube link : https://www.youtube.com/watch?v=dTerGYz8Bv0

Below are the plate specifications :

First thing you have to do is that when you call T01 you should be sure that the tool is in the center of the spindle and not above or under the spindle line so you know mehcanical the turret is coming correctly
after this is done ,you need to adjust the sensor cam for specific tool decode
As far as i see you can adjust the cams that make the sensor confirm
Ussualy in the electric book you should have the combination of the sensors for tool numbers ,something like this-this is an example
000-T01
001-T02
010-T03
011-T04
100-T05
101-T06
110-T07
111-T08

You need to check in the book what order is for your turret
Should be also a sensor for turret clamp but i do not see it in your video or photos.
do you have the electrical book?

Thank you for responding, I don't have the electronic book unfortunately , would you kindly guide me on how to download one and which specific one I should find ?

The Manual's shown is what I have managed to attain for my machine, would really appreciate the guidance to get this machine in working order. I am based in South Africa - Kwa Zulu Nata - Durban , I have made attempts with several specialists who just became a financial affair as they never resolved the matter.

Pm me [email protected]

@phucrobusl , Please confirm that the email is correct as I have sent an email to that address and received a response that I have the wrong person.

.

Wrong. [email protected]

Quote:

---

Originally Posted by phucrobusl

Wrong. [email protected]

---

Hey buddy, I have sent you an email. Would really appreciate your help.

Please could anyone assist me, would appreciate any help if based in South Africa