Re: Hitachi Seiki Repair / Service / Support
Quote:
Originally Posted by
Hitachi-parts-usa
Hello Dan,
If John can not help you. WE would be happy to assist it sounds like you need a reload on your seiki. Let us know if you need any information about your machine or parts as we have a vast inventory of parts available.
[email protected].
-A.J
Thanks AJ;
short question: is the ladder lost on battery failure?
I have a doc from Hitachi that implies no.
SV03-999-62-010 instructs how to swap the ROM chips
Re: Hitachi Seiki Repair / Service / Support
Quote:
Originally Posted by
Desertrunner
Hi all,
I have a Hitachi Seiki VM40 and I want to redo the electronics, so the plan is to replace X, Y & Z drive motors and drives and only keep the current spindle and spindle drive which are Fanuc, the motor is A06B-1003-B300 and the Control unit is A06B-6044-H103. I am not fused about being able to tap and cut threads so if someone could suggest a simpler spindle I would be happy to change. Sadly I don't have any circuit diagrams as I had someone else helping and they dropped off the edge of the world with my books.
Plan is to use Centroid equipment were possible.
Any help would be greatly appreciated.
Tony
It is better to change the AC servo spindle motors and drivers too, to get the best performance and best compatibility.
Re: Hitachi Seiki Repair / Service / Support
Quote:
Originally Posted by
Hitachi-parts-usa
Hello Dan,
If John can not help you. WE would be happy to assist it sounds like you need a reload on your seiki. Let us know if you need any information about your machine or parts as we have a vast inventory of parts available.
[email protected].
-A.J
AJ...your email box is full
Re: Hitachi Seiki Repair / Service / Support
hello ,i lost my Hitachi Seiki TF-20 Powermate sram,i need you help! can someone send it to me? or i can pay for it , thanks!! my gmail :[email protected]
Re: Hitachi Seiki Repair / Service / Support
dear friends,
i have hitachi seiki vm40 with seicos my3...
after on:
it cannot to booting because : motion rtc unready...alarm,
the 5. led (akku) is dark !!
i replaced the akku , but the alarm no changed
can anybody write to me what is the problem ?
i have no parameters ( if they lost…i think that)
can anybody send the procedure to mend machine and
can anybody send the parameters?
regards, kiss
Re: Hitachi Seiki Repair / Service / Support
I need service on ht25s and ht 23s nethier machine will start alsovg45 please contact Dave at sterling precision at 860-564-4043
Re: Hitachi Seiki Repair / Service / Support
Does anyone have the parameters required to turn on some of the options on the YASNAC MX3 control? I have a Matsuura MC-510V and have contacted Matsuura who said it's no longer supported and that they would try to get the information from Yaskawa who said the same. I'm out of options as far as getting them from the manufacturer as it's no longer supported and am looking for help keeping the control useful.