-
Hawke 150 programing
Hi guys,Gotta run a small program with a bar puller on my cincinatti hawke 150 with a2100 control,could anyone tell me what the command is to loop the program 20 times I have looked through the book but it does'nt say exactly where to start.We dont normally run lots of parts and just use barstop and restart,but it would be nice to let it run on its own for multiple parts.A small program example would be much appreciated to get her started thanks in advance.
-
Hawk 150 programming
Hello Greg
it's been a long while since i programmed but try this
at the start of the program put in a 'count'
ie :g0t1m6
[#count]=0
[here]
program
"
"
"
at the end of the programme
[#count]=[#count]+1
(IF[#count]<20 GOTO [here])
M30
you'll find it in chapter 10 of the programming manual.
regards
mallardfizz
-
Thanks for that Dick,I will give that a go in dry run (maybe) or in a small program with no stock in the chuck.regards Greg.
-
Tried that program loop Dick it worked pretty much spot on bar a few nitchy bits,I went through chapter 10 and really cound'nt find to much there,my manual may be a bit different.Thanks once again Greg.