-
I just installed the PC software Datapilot 4110 for our Kern CD 322 with Heidenhain controller in order to move along a DXF contour.
Now I get the following error message when I import a DXF contour that was created with Autocad 2000: “general error when converting DXF”
If I use the example runner, then the program takes the DXF.
If I save the runner in autocad 2000 DXF format beforehand, then the same error message comes up.
Does the program has a general problem with the Autocad DXF format or am I doing something wrong?
-
Hello Basti,
Maybe you have another layer like dimensioning or anything else on top of the drawing and that’s why your DXF is not supported.
As far as I know the DXF version 12 or 14 work best according to Heidenhain.
It should be explained in the manual.
Kind regards
Alex
