MIB press brake with Cybelec DNC 70 problem

I recently purchased a second-hand MIB press brake with a Cybelec DNC 70 control system.

It is not working properly. It doesn't work on semi auto mode even after feeding in the material data. On manual mode it comes down and goes up once, then you have to restart the machine. Sometimes, it totally refuses to work. The back gauge is not working and the x axis doesn't appear on the screen.

Please advice what to do.

hey anoopka !
just disable the x and r parameters(if existing).
and go to the beam page and set the mex limit smaller then the existing.
and then check the machine.also increase the sync valeu .
or send me the screen shots of machine parameters then i can help you
and we can tailor the parameters , step by step.
hope it will help a bit.
regards

Quote:

---

Originally Posted by sohail0110

hey anoopka !
just disable the x and r parameters(if existing).
and go to the beam page and set the mex limit smaller then the existing.
and then check the machine.also increase the sync valeu .
or send me the screen shots of machine parameters then i can help you
and we can tailor the parameters , step by step.
hope it will help a bit.
regards

---

hello solail110 I have a hammerle with a cybelec 7000 and my press is not working the X and M axes . how I disablethese axes can you help me please
thanks.
atte
lucioluciano

Hello friends ,

we buy in the past a Gasparini POA 80 but the operator of the machine is no more :(
So nobody knows how to use the machine
we don t have any instruction guide .
Is there anybody that can help me ?
maybe we can use a Video Call to simplfy the work

Thank you

My wattsaup is 0040745373715