2 Attachment(s)
Plunge rough down to one pass?
Is there anyway to get this down to one pass? The cutter is 1" and even when I shrink the flat width to .3" I get two columns. I just want one path right down the middle. I don't feel this should be that complicated but I can't figure it out.
I have tried several different combination of contain and avoid area. I am using a face feature since a boss feature doesn't have a plunge rough option.
Re: Plunge rough down to one pass?
Can you post a screen shot of what your trying to do
1 Attachment(s)
Re: Plunge rough down to one pass?
Quote:
Originally Posted by
sundewzer
Is there anyway to get this down to one pass? The cutter is 1" and even when I shrink the flat width to .3" I get two columns. I just want one path right down the middle. I don't feel this should be that complicated but I can't figure it out.
I have tried several different combination of contain and avoid area. I am using a face feature since a boss feature doesn't have a plunge rough option.
Are you using "Automatic" or "User Defined" under the "Facing" tab?
If you change it to "User Defined" you can manually define it as a single pass and it should put that pass straight thru the center of the boss. See the attached pic.