Some reasons for your machine....
Abusima,
1.please check if your material had exceed machine working size,if this,the limit switch will start on to protect by itself(e.g. your machine is 60x90 and your mateiral size is 12x24)
2.is your machine come back to the mechanical original point??
please check if these two reasones,
any unclear pls send me eamil.:devious:
Mike
[email protected]
发件人: Hatim Abusima
发送时间: 2011-10-11 19:45:28
收件人: mike
抄送:
主题: ncstudio
hello
i have a cnc router from china
but it is not working.
i have install the software from nc studio i think at the good way.
I installed the software and it found the pci card correctly.
I turned on the cnc and then opened the ncstudio software, once i did that the X-Y-Z Axis started to move by them selfs.
when they reached the limit switch's they still continued and started to make a grinding noise so i tund off the main power to the cnc.
when i looked at the software it had an error "limit switch on".
so i think i have bad version of ncstudio
please help me with this
thanks
1 Attachment(s)
Spindle & VFD Inverter NOT Working
Hello Mike,
I found your advice very helpful regarding the NC Studio installation, however I'm still having problem with running the spindle with VFD inverter by NC Studio.
My VFD Inverter Brand is (Aut-Drive) and its model No. (DVA-2S0022GS). I can't figure how it should hooked-up with the Controller driver.
Is this the correct wiring for the spindle & VFD? http://www.salecnc.com/images2/contr...tupCardEng.jpg
PIN 12 = Spindle Low Speed
PIN 13 = Spindle Middle Speed
PIN 14 = Spindle High Speed
Is there any fourth PIN I should hook-up with the VFD? May be ground or +5V pins?
I found a Chinese manual for the VDF inverter: http://ftp.gongkong.com/UploadFile/d...4301800001.pdf
Can you help me to understand what's mentioned in the table in page 3-6?
http://www.cnczone.com/forums/attach...1&d=1324977494
Re: problem with ncstudio and cnc router
Hi everyone!
Im having trouble using my CNC machine!
I just bought a CNC router from china
I'm using NC Studio and a PCI card I'de install the software just like you guys said (Install the software, turn off the computer, install the PCI card, turn on the computer, install the drivers and open NC Studio) and apparently the software opens fine but if I press Z+ it suppose to move up but it doesn't move!!
I've been struggling with this problem for about 15 days and I don't know what to do!
I've watch like 20 video tutorials and read a bunch of forums but nothing!
The people that sell me the machine doesn't answer my cuentions :S
HELP SOMEONE!!
Re: problem with ncstudio and cnc router
Hi all,
I am having problems to run CNC router for glass engraving,
Its a Chinese make cnc machine model SKS-1224L.
Have installed the NC studio also connected the machine,
all was going well till the time the spindle started, and the machine started moving in -Z & -X direction and banged to the frame.
have stopped working as the machine is started the spindle starts rotating and dashes to the side frame.
Have been struggling through this from past 5 days,
have tried re installing the NC studio but no success,
plz help as i cannot start the machine as the spindle starts and hits the machine frame so have to do it in off condition....