1 Attachment(s)
Problem. Losing power (strenght) when set to more than 60% power.
I have a BODOR laser with tube RECI 90W. I have this problem for a while.
Laser has no power up to 30%, and starts to lower above 60%. I changed the power supply, but this didn't help, problem stays. At 20 % current meter shows 4 mA, at 50% - 12 mA, at 95% - 26 mA.
They tell me it might be a problem with the tube. It worked only 100 hours but it's 6 years old.
I will attach a picture with a test I made using different percentage power at 10 mm/s speed, so you see what I mean, if I was not good enough in explanation.
Did anyone had a problem like this. What do you think is the tube the problem, or there might be another reason?
I would really appreciate your help.
Attachment 451993
1 Attachment(s)
Re: Problem. Losing power (strenght) when set to more than 60% power.
Quote:
Originally Posted by
martin_av
I have a BODOR laser with tube RECI 90W. I have this problem for a while.
Laser has no power up to 30%, and starts to lower above 60%. I changed the power supply, but this didn't help, problem stays. At 20 % current meter shows 4 mA, at 50% - 12 mA, at 95% - 26 mA.
They tell me it might be a problem with the tube. It worked only 100 hours but it's 6 years old.
I will attach a picture with a test I made using different percentage power at 10 mm/s speed, so you see what I mean, if I was not good enough in explanation.
Did anyone had a problem like this. What do you think is the tube the problem, or there might be another reason?
I would really appreciate your help.
https://www.cnczone.com/forums/attac...d=451993&stc=1
https://www.cnczone.com/forums/attac...d=452092&stc=1
If you do a raw beam laser burn into clear plastic (prior to a mirror), then if the shape (mode) of the beam is bad (not a hill shape), then the gas is bad (consumed, leaked out over six years, contaminated, etc.) and you need a replacement tube. This photo show what a bad mode example looks like, with the laser gas consumed. It is from a RECI 150 watt laser. In this video, I am doing a mode burn into a block of acrylic.
https://www.youtube.com/watch?v=28br8lxqBg0