Matsuura MC-600V ERROR and ALARM
Hi,
I am using a Matsuura MC-600V with a MX3 Yasnac controller.
I had a program running when it did a tool change the machine came up with an error and alarm that will not go away.
182: SEQ ERROR2
424: TOOL TABLE ERROR
The tool was placed in the spindle ok, and the old tool was placed in the pocket. The pocket stayed down and never went up.
Any one know how to clear this error?
Is there a way to move the arm manually to check if it is in the correct location?
Thanks,
Saul
#6219 toggled, everything ok.
Hi,
Just toggled SETTING #6219...
Everything ok now..
Thanks,
Saul
Re: #6219 toggled, everything ok.
Reviving this old thread. At tool change arm his spindle and dropped tool, I have the SEQ 282 error and the 434 tool table error. I put the arm back into position manually but can not toggle #6219??? I have the manual to reset tool table but even though I replace arm, I still get error. Unsure if it wont let me toggle #6219 since it is in alarm???
any help is appreciated.
Dan
Re: #6219 toggled, everything ok.
Never mind, I was in parameters not settings