Can someone provide me with the subprogram from a Haas control that does engraving? It is subprogram #O9876.
Thanks in advance!
Printable View
Can someone provide me with the subprogram from a Haas control that does engraving? It is subprogram #O9876.
Thanks in advance!
I went to find this in my control...turned setting 23 off, and it wasn't there. But, I ran a G47 program and in single block I can clearly see that the O09876 program is running. If I could figure out how to get it off the machine, I'd gladly send it over...I'm curious about how to recover these "hidden" programs.
I believe it is a macro subroutine...
You recover them by saving them to a computer so you can re-install them if bad things happen.;)
*BUMP* Anyone have any luck finding this?
I have it in front of me now. I can either paste it on here or email it to you.
paste it here please
Here it is: O01112 (ENGRAVE SEQUENTIAL SERIAL NUMBERS)
T7 M06
G43 H07
G00 G90 G54 X1. Y-1. Z1.
M08
S6000 M03
Z.1
G47 P0 X1. Y-1. J0.18 R-0.2 Z-0.01 F75. E50. (S/N)
G47 P1 J0.18 R-0.2 Z-0.01 F75. E50. (#####)
M09
G00 G28
M30
Hey guys,
Sorry I couldn't get it posted today. Shortly after I replied I got swept away into the shop, never to return to my computer to do what I actually needed to do. I'll send it out tomorrow sometime in the AM. It's a long program, at least longer then the few lines written above. But I'll paste it here unless told otherwise.
Edit: Ok so I'm looking at this file and it's very long. If you want it I'd be best to shoot me a PM and I'll email it to you.
Hello,
Here is O09876 makro program from NGC machine.
I hope it will be of some use.