Re: PathPilot X axis glitch
Which 1100 model do you have selected? The exact name will be shown to the right of the path pilot logo near the Exit button on screen.
On the Settings tab, do you have Enclosure Door Switch checked? Do you have an enclosure door switch wired in?
Re: PathPilot X axis glitch
Quote:
Originally Posted by
old-cnc-geek
Which 1100 model do you have selected? The exact name will be shown to the right of the path pilot logo near the Exit button on screen.
On the Settings tab, do you have Enclosure Door Switch checked? Do you have an enclosure door switch wired in?
It's a Series 3 (excuse me)
Wtth the symptom of tripping the x limit switch and observing the enclosure door switch light up on the status page I reasoned that the Path Pilot software was corrupted.
The door enclosure switch on my machine guards the motor and pullys.
PROBABLY because I accidently did not follow proper shut down ettiquate of Path Pilot during the very previous run. Operator induced.
I wiped the hard drive and reloaded Path Pilot. Problem resolved.
Thank you for responding!