Mazak T32-3 Alarm 015 System Malfunction
Hi guys,
I've got a Mazak SQT15MS T32-3. When I turned it on today the keys at the operation panel were not working and a few minutes later Alarm 15 "System Malfunction" came up on screen. I restarted several times but the same result. I looked in the electrical cabinet and when it's started initially all the drives LED's appear correct (i.e.: X/B Drive :Flashes between d1 & d4 . Z Drive:d2. Sub Spindle Drive: r0 . Main spindle Drive r0.) but after a few minutes the main spindle drive LEDs go blank, showing nothing (that's when the Alarm comes up on screen).
In the Alarm manual it says the following :
Alarm 015 System Malfunction.
Cause: An error occurred in data transmission between MCP and the Amp when the power is turned on.
Action: Check Amplifier for :
Improper connections.
Improper power connections.
So what I'm wondering is what is the MCP and what Amp are they on about ?
Any advice please ? Is this a sign of some problem anyone is familiar with ? What's my best course of action ?
Need Help! Mazak T32-3 Alarm 015 System Malfunction
Hi,
Is the spindle drive FR-SF? If so, check the Yellow LED on the SF-PW (power supply) on top side of the Spindle Drive.
If it is off, there are several reasons,
1) Any of feedback cables grounded.
2) Faulty SF-PW.
3) Faulty SF-CA card.
Regards,
Girish
Need Help! Mazak T32-3 Alarm 015 System Malfunction
Hi,
Problem could be the CAM11 cable or the MCP/CPU (MC1xxx) card on CNC from which this cable comes out.
If CAM11 cable is ok, need to check
1) Memory clear & reload from backup
2) Replace MCP/CPU card & check.
May be MELDAS service engineer required for this.
Regards,
Girish
Mazatrol 640t 15 system malfunction
Hello There
We do have the same error on Mazatrol 640t 15 system malfunction so i was wondering did you got your machine working back to normal.
On our machine it started with RTC battery error and will not boot to win95 so replaced the battery then did boot but at last it stuck on this error all though the all functions works eg spindle spins, tool changing but can not get reed of this error.
Please do let me know if you do got your sorted.
Thank you