-
Ladder on 0T
Hi
I tried to set bit#2 of parameter 60, so that bring the ladder up on the screen, but it's impossible to change this parameter. How can I open ladder? PWE was = 1. Is it real to extract ladder from control via RS232 and open it in Fanuc Ladder III?
Regards
-
If it is on EPROM, no way. See on the memory board, if 0F1 and 0F2 exist (or 011, 012?), there is the ladder. If so, contact me, I can help
-
Can you read the parameter 905 of your machine?
-
Parameter905
Hi
If your option parameter 905 is 0001000 ,your controller do not have any of
PMCL/M,so you cannot display the ladder
tungtung
-
Hi
If your controller is fanuc 0MB you can not view ladder diagram
-
Re: Ladder on 0T
hello!...do you have the binary files of the master card A16B-1010-0210/16D of the Centrum 3000 punch press...they are OE1, OE2, OC1, and OC2...the executive software version is 0130-11?