Re: Anilam 1100 Controller Problem
i just encountered the same problem,replaced the battery but lost all memory (i guess) cant get it to run again(when servos activate the table just goes in -y for about 3" then shuts down the servo)
what settings did u have to reenter? did u use a floppy for the computer or the manual for the control with the password?
steve.
Re: Anilam 1100 Controller Problem
Hello
How did you solve the problem for your Anilam 1100 cnc control.
i have similiar machine with the same problem like yours. Same errors. How did you fix that.
Please send me the details
Thanks in advance
Re: Anilam 1100 Controller Problem
Hi could you give me the engineers contact in the uk , I’ve got issues will my mill had the cmos errors changed out the battery but now won’t boot , not to good with computers so need to get someone in ASAP
thanks
paul
Re: Anilam 1100 Controller Problem
Quote:
Originally Posted by
Pauldhar
Hi could you give me the engineers contact in the uk , I’ve got issues will my mill had the cmos errors changed out the battery but now won’t boot , not to good with computers so need to get someone in ASAP
thanks
paul
Hi Pauldhar,
Its Bouvier Jerry
His email id is [email protected]
But the problem is since they have put the 1100M controller into absolute and they are not providing the service for the same. They can give a upgrade for the same controller.
In the meantime if you have time , please check the input supply in the cpu,check the cmos battery for 3.6 volts and the button cell for 3 volts..Check if there is any damage in the electronic components. Use a magnifying glass to check the components for any oxidation on the solder joints or burnouts.
Thanks and regards
Clide
Re: Anilam 1100 Controller Problem
Thanks I managed to get a Cpu Card from a 3300 which does have a blue wire soldered to it , I have now managed to boot but I don’t know how to get it set up as I can start the servos now but they move 3” and switch off . We do have an autolube on it so I’ve read that I may need to check that but also we now have a separate power supply for the pc . I get dead stop switch reached and when I start servos I get error spindle or prog. Controller disable .
not too good at this but getting there any more help would be appreciated
paul
Re: Anilam 1100 Controller Problem
Hi blakey235 could you let m have the anilam engineers email in the uk please , I’ve tried the guy in the states but it just gets pinged back
thanks
paul