Printable View
I am attempting to install a touchplate on my home made cnc. I am using mach 3 and on the diagnostic page the digitize light is already lit up. Even with nothing installed in pin #11 (where I have it configured for). If I switch active low to off the digitize led goes out but the touch plate still will not work. Any ideas?
What type of touch plate are you trying to use.Quote:
Originally Posted by Dixieman
I am using an aluminum piece with a wire attached to pin 11 and the other to the ground on the board. The ground has an alligator clip to attach to the router. Supposedly when the bit touches the plate.it connects.the circuit. However the digitize light which is not supposed to be lit on the diagnostic page in Mach 3 is on. Even when the probe is disconnecteQuote:
Originally Posted by mactec54
Is your spindle Grounded, if not this will not work, check the continuity between the 4th Pin and the spindle bodyQuote:
Originally Posted by Dixieman
You may have shorted that output if the spindle is not Grounded the Board can be damaged with this type of tool setter
These types are best no chance of a spike that can damage the Board