We have a Johnford lathe with a fanuc oi-tb controller. the controller starts okay the gives a 1107 turret servo alarm. What should i be looking for?
Printable View
We have a Johnford lathe with a fanuc oi-tb controller. the controller starts okay the gives a 1107 turret servo alarm. What should i be looking for?
You should be looking for your
MTB Manual with alarm descriptions ......
A turret servo alarm is not a Fanuc alarm
I realize that it's not a fanuc problem. there is not a mitsu turret board on this site, and I can't figure out what these people did with the manual.
Just throwing spaghetti on the wall. Thanks Monkey
OK A few more details wouldn't go amiss !!
I.E.
Machine Manufacturer + Model
Control Manufacturer + Model
Relevant Servo Amplifier and Motor Models
And a description of what is happening/not happening
With this info we can start to help
If it is a Mitsubishi Control I suggest you post this info in this forum
http://www.cnczone.com/forums/forumdisplay.php?f=111
i have the same problem.1107 turret servo alarm..its a johnford sl-500 with the fanuc oi-tb controller,it has the golden sun turret on it,i cant get the alarm to clear,or zero the machine out or anything...any help????thanks
I just got this error fixed on my Johnford SL-300 after crashing the turret. I followed these instructions from my manual, and it worked.
Attachment 240936
This is on page 53 on in the operation manual.Quote:
Originally Posted by evilusions
We have found that this alarm can not be cleared until changing the 3.6v lithium battery located on the turret drive in the main cabinet out back. We do this battery change while the machine is powered up. After the battery is replaced we go through the turret resetting routine found in the machines manual.Quote:
Originally Posted by speedmaster
Fixed or not
Fixed or notQuote:
Originally Posted by tdl1