Printable View
Hi there CNC Gurus.
Where I work now have 2 older EZ-Traks.
I used to have the software to use on a PC.
Does anyone in CNC land know where I could get another copy?
The people at work use it as a Bridgeport with a readout on it "ONLY"
Please advise.
Thanks
No Disrespect but this is the second question I've asked with no responces.
I went from the MasterCam forum to here.
Second thoughts....
Here is what I have. I think this is the machine boot disk. I don't know if you can run it on a PC. I think it searches for the drives on boot and errors if none are found.
Thank you txcncman.
I will give it a try.
Hi Ken,
It works?
i have a Bridgeport EZTRAK 1992 and need software.
very important to me your comments.
regards
Hi Txcncman
I have downloaded the boot disk will try on my machine
Can this be copied to a hard drive as my machine has both Floppy & Hard drive
Thanks
Bill
Wow, what an old DOS.
You can boot your computer from the floppy on which you have to unzip this archive.
Autoexec.bat will do the rest, i.e. copy and expand needed files to your C drive
maybe you better order an individual development?