T32-3 no M commands after reinitialization

Hello,

I have this problem. After we lost parameters due to a faulty battery I did a reinitialization procedure for T32. I pulled parameters from the eeproms, Cleared all the areas to finally start the machine without any alarms, BUT I could not send home, SO I had to re-establish the home position with an instruction manual that I downloaded from the mitsubishi website. FINALLY, after numerous attempts the machine made it to the home position.

NOW, MY PROBLEM NOW IS I can not get the chuck to open and close AND I can not turn the coolant ON and OFF in MDI mode. The chuck works fine in manual mode

Any ideas?

Thanks for the help

jolulank