Printable View
Hello buddies,
I lost my fuling inverter DZB200 series because of uppervoltage (Electricity in Cameroon is a mess).
I ordered a new one but the seller sent me a DZB300 series. Can I use it with my 1,5kw soindle ?
If yes, how to set the parameters ?
I count on your answer because I am afraid of any misuse.
Thanks in advance
Sure if the VFD has a Kw Rating that suits your spindle, the old one most likely failed because of wrong Parameters setQuote:
Originally Posted by bivegele
So if you have the VFD to Match the Spindle there will be no problem no matter what model the VFD Drive is
Spindle spec's
Kw 1.5
Amps=??
Hz=??
Voltage=??
VFD Drive spec's
Voltage=
Amps= output
Salut bivegele je suis au Cameroun et j’ai un problème avec mon inventer dzb300 je l’est configuré mais ma broche ne tourne pas. Comment faire?
J’aimerai avoir ton numéro voici le mien +237699570073
conect the motor directly without the inverter.
How could you post such a thing without knowing the motor spec'sQuote:
Originally Posted by Algirdas
Thanks for your concern. These are the informations about my VFD and my Spindle :
Spindle spec's
Kw 1.5
Amps = 5 A
Hz=400
Voltage=220
VFD Drive (Fuling brand) spec's
Voltage= 220
Amps= 7.0 A
Can I get the procedure to restore default parameters of the Inverter. I want to reintroduce the correct settings to the VFD in case it could solve the problem.
https://ae01.alicdn.com/kf/H93cd71ea...710df8313D.jpg
https://ae01.alicdn.com/kf/H727375f0...b2ef9c7a7h.jpg
- - - Updated - - -
Bonjour Fabrice. Vous avez quel type de machine ?
- - - Updated - - -
Mon numéro est le +237694438248
I apologize for that oversight. Thanks for your concern. These are the informations about my VFD and my Spindle :
Spindle spec's
Kw 1.5
Amps = 5 A
Hz=400
Voltage=220
VFD Drive (Fuling brand) spec's
Voltage= 220
Amps= 7.0 A
Can I get the procedure to restore default parameters of the Inverter. I want to reintroduce the correct settings to the VFD in case it could solve the problem.
I must say taht after introducing all the parameters in the VFD, the spindle doesn't turn even when I try to lanch it by command in NCStudio.
https://ae01.alicdn.com/kf/H93cd71ea...710df8313D.jpg
https://ae01.alicdn.com/kf/H727375f0...b2ef9c7a7h.jpg
F0.12=1 will restore the Drive Default Parameters, you will then have to reset the Parameters for your spindle specsQuote:
Originally Posted by bivegele
Thanks a lot Bro. I right now go to my workskop to do that.