Can't indicate Tool holders on daewoo lathe
This is a 1998 deawoo puma 200 lathe, Had to remove the alignment button on the turret so I could indicate the tool Holders(blocks) in, I guess the machine had been crashed hard but had been fixed, I indicated the turret face, turn tool pocket, and side, the worse i seen was .0015 is that enough to have to pull the alignment buttons to get in line? thanks for any help
Re: Can't indicate Tool holders on daewoo lathe
Tolerable if it is below the spindle axis, unacceptable if above.
"Above" and "below" in regards of spindle rotation direction.
Re: Can't indicate Tool holders on daewoo lathe
Interesting, thanks for the reply