C11, ESS and (or) Mach3 issue, no axis movement
If anyone could give me some places to look. I have no axis movement. Controller did work at one time, but computer was upgraded and now this. I have not messed with it for some time now so am very green.
-Mach3 and ESS are communicating
-5V exists between the EN and 5V on the C11
-1V on ports 2,3,4,5,6,7
-5V on ports COM*
-Stepper drivers are powered and look good to go
-Ports are enabled in Mach3
-No port lights on diagnostic screen
-I have no stepper movement and no status LED's are lit
-My C11 is rev 9.8
1 Attachment(s)
Re: C11, ESS and (or) Mach3 issue, no axis movement
Re: C11, ESS and (or) Mach3 issue, no axis movement
You can reach out to us on our ticket system and we will give you a hand with this:
https://www.cnc4pc.com/contact/
Arturo Duncan
https://cnc4pc.com
3 Attachment(s)
Re: C11, ESS and (or) Mach3 issue, no axis movement
Here are some of the settings pages in Mach3. I've created a trouble ticket.....but you and I were already emailing.
If anyone can give me some points to check, it would be appreciated.
Attachment 433462Attachment 433464Attachment 433466