Re: #2018 Turret Run Alarm (A4.2)
thank you Mr zavateandu for your replay ... I changed the PWE to 1 and it worked with me
Re: #2018 Turret Run Alarm (A4.2)
Quote:
Originally Posted by
Ahmed18
I know the Instructions
1- Keep-relay No. 7 bit No. 5 must be 1 (Turret JOG Mode)
2- Change to Handle Mode
3- Feed HOLD + Spindle STOP
4- The turret will unclamp
5- Click on the +X and -X to rotate the Turret
My problem is at step number 5 cuz the turret doesn't rotate
So how did you able to fix this problem?? because I'm currently in the same situation.
Re: #2018 Turret Run Alarm (A4.2)
if the turret is not rotating it means that or is not unclamped by hydraulic cilinder or is unclamp but the sensor that should see it ,is not working.
check in diagnose the input for the sensor if it is going from 0 to 1,if not,try to adjust the sensor or replace it if is broken.
the turret will rotate only if the cnc see the senor for unclamp in 1 position ,otherwise will not rotate.
Re: #2018 Turret Run Alarm (A4.2)
how to fix this alarm sir
Re: #2018 Turret Run Alarm (A4.2)
Please send me the procedure i have the same problem on my cnc lathe goodway
Re: #2018 Turret Run Alarm (A4.2)
Can you send me the procedure
Re: #2018 Turret Run Alarm (A4.2)
Quote:
Originally Posted by
firekoe
it turned out that the batteries where died and i need to replace them then index the turret if anyone needs the order of operation to do this i have it now as i could not find it in the book so just post if you need help with this problem
Please I need this procedure. I know it's long period from the time you posted but I hope that pdf still around