Managed a bit more work on the panel, my only concern will be noise.....i would like to have the panel done before he drops of the machine
https://www.cnczone.com/forums/attac...d=422010&stc=1
Printable View
Managed a bit more work on the panel, my only concern will be noise.....i would like to have the panel done before he drops of the machine
https://www.cnczone.com/forums/attac...d=422010&stc=1
Hey Erick.
Could you tell us who made your 6 axis bob?
You sais it was an aussie company i think?
Panel should be completed today, usually i wire outside the box but because space is so tight i have to wire with the backplate installed...
https://www.cnczone.com/forums/attac...d=422056&stc=1
Thank you:)
He stripped the machine down today and sent me some pics.
https://www.cnczone.com/forums/attac...d=422074&stc=1https://www.cnczone.com/forums/attac...d=422076&stc=1https://www.cnczone.com/forums/attac...d=422078&stc=1https://www.cnczone.com/forums/attac...d=422080&stc=1https://www.cnczone.com/forums/attac...d=422082&stc=1https://www.cnczone.com/forums/attac...d=422084&stc=1
Completed the wiring...Will be testing soon, then a bit of tidying up and changing a couple of circuit breakers:)
One thing i found was that although the Gecko is a nice and compact unit, wiring layout to it was a pain. So it's unlikely that i will use it in the future. I like the fact that if i have separate drives and bob i can change individual units if there are failures plus it's easier to do separation between control and main power. I am a little worried about electrical noise
https://www.cnczone.com/forums/attac...d=422190&stc=1
Looking good erick.
You sure know how to make it neat and tidy.
Puts my enclosure to shame.
Been meaning to ask you if you could help me wire my delta vfd to my bob for spindle on/off control. My bob has a relay output for control but not sure which connections on the vfd to use?
Thanks....no problem, i just need the Delta vfd model, bob details and control system details:)
Wow nice work
I always visualize my work to look like yours.
I start with a Monet mind and end up with a Picasso finish.
I love the machine
I am starting a 4x4 to replace my 2x2
Looking forward to seeing how its going to run with the new hardware
i have tons of questions
Thank you. The owner of the machine has a couple of roland engravers. He used this machine to carve amazing guitars but had too many hassles. Now he's ruining his small machines to do the work. Hope to have it working a bit better soon. Please feel free to ask anything. I will assist if i am able to:)