[jubee]

Hello all,
As per the title.........
I would be very grateful if someone had a fusion 360 post for Okuma LB15 OSP5000L.

I have tried using the ones made available but doesn't seem to compile the basic thread cutting, uses G32 and just inserts the Z valve and doesnt use the G33 'X" "Z" F code

Anyone with a working post would be great to hear from
Thanks in advanced

[jubee]

Ok , further to my above post , anyone care to send a very basic metric threading Gcode file i can try.

This is doing my head in .....
I tried what what was written in the Okuma operations manual and didn't work , it gets to the Line G33 and stops , no errors , axis just stops with the spindle still running , its like its waiting for something.
I have also looked over the manual and cant see what could be the problem.
I see that G71 is used on osp 5000L and G33 for thread cutting.
When using fusion it inputs G32

This is a old Okuma lathe LB15 around the early 80s with OSP 5000L controller

Is there any way you can look up the parameters to see what gcode it understands...????

Any help would be great
Thanks

[jubee]

This is written straight from the book

%
(Thread test)
N181 M1
N183 G0 X500 Z200 M42 S350 T1010
N184 X120 M08 M03
N184 G33 X89 Z150 F1.5
N184 X88
N184 X87
N184 X86
N184 X85
N184 G0 X500 Z400 M09 M5
N185 M2
%



And this on is from fusion 360

%
(TEST G71.MIN)
N10 G50 S3000
N11 G0 X500.
N12 G0 Z500.

(THREAD1)
N13 T101010
N14 G95
N15 G97 S500 M3 M42
N16 G0 X62. Z220.
N17 G0 Z214.5
N18 G71 X16.15 Z197. D0.32 H1.6 F1.5 M32 M73
N19 X62. Z220.

N20 G0 X500.
N21 G0 Z500.
N22 M2
%



Both stop at the threading part with no errors .....any ideas ? anyone

[jubee]

Ok ,
So those of you that are following
Not sure why......But this threading code is working only with the dry run switch on.
I will start a new thread to ask why this could be .....as far as the request for a fusion 360 post , looks like what I'm using is working so disregard the request for a fusion 360 post.