I'm currently using Fanuc DNC software to drip feed programs through a fiber optics cable into the HSSB port on the control using and old PC with Windows 2000.
I'm replacing the PC with a Window...
Type: Posts; User: darrelt
I'm currently using Fanuc DNC software to drip feed programs through a fiber optics cable into the HSSB port on the control using and old PC with Windows 2000.
I'm replacing the PC with a Window...
My Toshiba 5 axis with a Tosnuc 888 control is alarming PC4-008 when running a tapping cycle.
This machine has Mitsubishi drives. I checked the spindle drive module and there were no red alarm light...
When the main power switch on the electrical panel is turned on the control boots up.
Then there's a green power on PB in the center of the pendant I push then the cycle start PB.
Then the machine...
I'm receiving a spindle alarm on my Hurco Mill that has a Yaskawa 626VM3 servo drive.
The machine was turned off over the weekend. When I boot up the control The display on the drive has F-A00....
I need to slow down the ATC arm rotation. It's way too fast. What are the steps to get to the parameter page and the correct parameter for this?