Hello,
I do not have a photo,
You hav a defective Eprom module or the CPU card will be defective.
The problem is, I live in Germany
that means it is not easy to help you.
Type: Posts; User: tld70
Hello,
I do not have a photo,
You hav a defective Eprom module or the CPU card will be defective.
The problem is, I live in Germany
that means it is not easy to help you.
Hello,
the red LED will be on ehen the CPU is not running,
If you press the Eye Button and switch on you will still have the alarm?
If yes, one of the Eprom Module is defect.
May this module you...
Hi Milan
can you provide a MachineNumber.
Regards
Thomas
Hello,
you only need the Parameters and some PMC Datas.
can you provide a Machinenumber?
Regards
Thomas
Hello,
you dont need a cycle for toolchange, all is in the PMC,
What you need are the option File, Parameters, PMC Keeprelais and DataTable.
If you put in all, your Machine will run again....
Hello,
can you provide a Machine Number?
You tell tht eye button does not help.
If this is correct I think you have a faulty Eprom?
I can check the Eproms here.
Wait for your reply
Regards...
Hello Andre,
I can provide the datas,
where I can send it?
Best regards
Thomas
Hello,
the datatable is in the PMC area
you have to press NC/PC Key to enter this area
here you will find the datatable and PMC parameters
Regards
Thomas
Hello,
86 means you have the wrong connection, wrong channel or wrong parameters.
you can look for the software cncmanager, there are some examples for connection to Fanuc controllers
Regards...
you can transfer datas very easy with the cncmanager,
it is a very easy to use software for transfer datas between cnc and computers
Regards
Thomas
Hello,
why to use a old tapereader?
you can use a computer with a transfersoftware like the cncmanager.
Hope this will help
Thomas
Hello, the PLC is on your harddrive, can you provide a machinenumber
Hello,
The M function for the pallet changer is M71.
Regards
Thomas
Hello,
please give me more infos, I can help you
Hello,
please look under Willkommen bei www.cncmanager.de
may this is what you looking for?
Hi Philip,
you have to fill out in the Setting Data your Working Area.
regards
Thomas
Philip
did you receive my email?
no response from you until now
hope it helps you
regards
Thomas
OK Philip,
if you are sure about this datas please
reply it on Monday, also I need the Controller Type
810 GA1 or GA2 or GA3
also I need a Email Adress where I can send the Datas
regards...
Philip,
dont care about the messages in this mode.
first you have to delete and load the ncmd
after this the plc datas
then the nc datas.
there no datas to load from the eproms.
can you give...
Hello
How did you reinitial the controller?
I dont thik a eprom is defective
Best regards
Thomas