Search:

Hi Joe,

Thank you for your help. Looks like I need to be prepared to have a pc with Dos installed.
I'll keep you updated on my progress.

CNC Programming, Inc.
Matt

Hello,



Can anyone help with this alarm error 9036 static RAM file system corrupted?
It discription in the manual is (There is a proplem with the C: drive file system possibly due to a battery...

Hi Gene,

During testing and further investigation. I have discovered the air supplied to the spindle is not a cooling device at all. The purpose of this air is to keep chips from entering spindle...

Hi JWC,

Normally the spindal drive that is located in the back of the machine in the cabnet is set up parmeters for each machine and not changed! If the spindle drive has lost its parmeters you...

Hi Joe,
I spoke with a cincinnati tech this morning. Man was he GOOD! He knew these machines in and out.

He told me that the reason the Control Techniques contoler slows during advanced surface...

Hi Gene,

I have begin lowering the air pressure and monitoring temp.
My suspicion is that when the machines were new less air escaped and over time they allow to much air pass do to wear.
I have...

Appreciate the advice Toby.
The max feed rate is 200ipm. I know that the machine can feed much faster then it is moving it is starving for information it can't get the lines in quick enough.
...

Hello,

Has anyone overcome the problem with the Cincinnati Milicron arrow 500 with control techniques information starvation while machining surfaces with several point to point moves to generate...

Hello,

I have two of these arrow 500 and interrested if these should using air (a lot of air)
while sitting not even running? If not how do I fix this? Did you find a solution?

CNC...