Search:

Can you share the PP on this forum?

Any here that can share a working PP for Fusion ?
Prefferably with support for 4th axis.

hi Suat, I do not have experience with the driver you are using but from what I can see in the documentation for it the 4 inputs are the same as for most other controllers. Hence, my expectation is...

makersuppplies.dk has just opened a web-shop for all OpenBuilds parts, V-slot and OX DIY CNC Gantry Plates made in Stainless Steel. V-slot linear rails will be available in length up to 2m from the...

It could be that your steps/mm is off. You can calculate the step/mm and get a very good first number. However, if you want to maximize the accuracy you need to calibrate the value by doing repeated...

For some projects I have used CamBam. In the profile tool menu you can specify a Cut Width. E.g. if you have a 3mm bit and set Cut Width to 4mm the bit will go around the profile a second time and...

AKZ250 Setup wiring - YouTube

I have spend some time setting up and wiring this card so I thought it would be worth sharing.

In the PDF attached made a wring diagram for motor drivers, E-stop,...

Hi Pradeep
YES U are my man!
Thanks a bunch for the tip. It Works!
I needed to do a little soldering to get the relay out of the board before testing (I was using one of the small Aduino boards...

Hi James

I have tried but w/o much luck. I guess that's the problem with these CN producers.

I have a link to their web page but no contact info. The reseller does not do much other than...

I'm working on wiring the 4 axis version of the AKZ250 USB controller. Motors, E-stop, limit sw and probing works just fine.

Now I want to set up a relay for power on/off the router.

In Mach3...