Be careful, Graphie dust is nothing you should breath too much of.
I have been using a shopvac with a replaceable filter bag. The bags are used for fine dust vacuuming, like drywall sanding dust. ...
Type: Posts; User: RJSheets
Be careful, Graphie dust is nothing you should breath too much of.
I have been using a shopvac with a replaceable filter bag. The bags are used for fine dust vacuuming, like drywall sanding dust. ...
The NC file names were different. Some of the steps were set to the old file name. My Bad.
Thanks,
I'm better now!
Thanks, I tried the insert arrow at the bottom. It allways wants to split the program at the same place, almost like I have set something in mastercam telling it to post as a two part program. It is...
I have a program that has about 5 steps in Mastercam X mr2. I wanted to make multi parts on a sheet, so I translated the toolpaths. I sequenced the part to the way I want them, and all looks well. ...
I have not found any good reference for rolled ball screw backlash. The best I found we in some notes of the Nookind.com book. They state that backlash will be between .003-.015 inch depending on...
Thanks, this will be another source for reducer bushings. I already ordered some from the link Phillby supplied earlier in the thread.
Yes, I have a collet extension for er-11 collets. I cut down the length of the extension so that it just extends out the the router collet. er-11 collets only go up to 1/4" and the er-16 (next size...
I agree with Carlnpa, you will get some runout with the bushing. Although for the tolerance I am working with, I'm going to try one. (thanks Phillby)
I was looking at around $200.00 for two...
I have been doing a lot of research on this and I cannot find a standard collet that will fit in the hitachi. ER-25 and RSO collets have different tapers. I am looking to a local tool...
I am looking for some different sized collets for my home router table that has a Hitachi M12VC head on it. I have searched the fourms without any luck. The collets look like ER-25 collets but I am...
By chatter of the countersink, do you mean that the c'sink is not round.
You can try to adjust speed and feed of the c'sink to reduce the chatter. The other thing to try is a different type of...
Here is their home page.
http://www.pennmotion.com/
I hope this helps
Actually a non ferrous circular saw blade (or table saw blade) works quite well. Check your local home improvement store, they usually have something in stock. Make sure you wear good ear and eye...
I wouldn't bother with MD, it is an obsolete piece of software. Autodesk is putting all of it's effort into Inventor (http://usa.autodesk.com/adsk/servlet/index?siteID=123112&id=4291253). Inventor...