I recently rebuilt my CNC setup with new motors and a G540 controller with Mach3. I have downloaded the XML file and have it installed. Everything with the G540 works fine to this point. I can jog...
Type: Posts; User: csdisme
I recently rebuilt my CNC setup with new motors and a G540 controller with Mach3. I have downloaded the XML file and have it installed. Everything with the G540 works fine to this point. I can jog...
This has been awarded.
Thanks to all that sent messages, your help is appreciated.
I need to have the gantry sides of a router I am building made up as they are just a bit too large for my X2 mill to handle. I would need them made from 1/2" aluminum, and have included the drawings...
I have a X2 that I have converted to CNC and I need to make a part that is right at the limits of the machines capability. I need to do some perimeter milling, drill a number of holes, and bore 3...
I will get it to you after I get back tomorrow (Saturday) with the information requested.
Thank you for your reply.
Best regards,
Cullen Demko
Please find attached a DXF file for a heat shield. This should be made from 20ga or 24ga mirrored stainless, although the finish is not important for the prototype. There are 3 models that will be...
Thanks for replying :)
I will give your suggestion a try and post the results.
I am new to the world of CNC, just finishing converting my Grizzly Mini Mill to CNC. I am using Mach3 and LazyCam and have designed a few pretty basic shapes and ran the DXF file through LazyCam and...
Thanks for your help.
I measured the resistance across the winding using the pin out diagram on Japan Servo's site and came up with 2.5
If my calculations are correct, that would put the...
Thanks for the reply.
I had found several references to the the 900 series also. The beginning of the model number matches up but not the last part. The "B" seems to be different than any of Japan...
I got several small steppers in an estate auction along with a bunch of other items. I would like to do something with these but I cannot find any specifications on them. I have tried searching the...