EIA/ISO Parameters F91
Set bit 5 to 1
This will move machine 5.0 increments instead of .005 if there is no decimal point
Type: Posts; User: billygreen
EIA/ISO Parameters F91
Set bit 5 to 1
This will move machine 5.0 increments instead of .005 if there is no decimal point
Hi all.
I want to be able to read in #vars from a file (sub prog) at the start of a job and then write them back to save for when job is next run. We use the vars for minor adjustments in work...
Not sure of the parameter.
Tool length data is stored in #vars #60001 and up (ie tool 1) on our machine.
If its always a factor of ten add the following line to your programs, after the tool...
not sure in mazatrol but in ISO on Mazak 640
G17 G92.5 X100.Y100.R5
Will rotate the datum 5 degrees in the anticlockwise direction. around the Z axis.
Safe side. Try it with a big value...
Tearing my hair out here.
Anyway to get Vericut 6.1 to pick up the following.
G0G90G54.1P1
Or if it won't work could someone let me know please.
TIA
We use the program that is listed below. We have numerous, up to 8 fixtures loaded on the machine at any one time.(The fixture locations never move)
It also allows the operators to adjust...