584,865 active members*
4,852 visitors online*
Register for free
Login

Search:

Type: Posts; User: funcutter

Search: Search took 0.00 seconds.

  1. Thread: x and y

    by funcutter
    Replies
    3
    Views
    2,678

    Re: x and y

    thanks for the help
  2. Thread: x and y

    by funcutter
    Replies
    3
    Views
    2,678

    x and y

    1 have a 5x10 router, i drew up a project on artcam but when i put it in mach3 my x and y are in the wrong directions, i want to know if i can rotate my project with my tool paths without starting...
  3. Replies
    1
    Views
    1,060

    intersecting vectors

    i keep getting the error "two or more intersections overlap " this is for making a toolpath. i have one cut that is shallow in one direction and a deeper cut going thru that other cut, how do i...
  4. Replies
    9
    Views
    732

    Re: cnc router wont finish cut

    my rpm was 15000, the 3.5k is HP. and it is two flute
  5. Replies
    9
    Views
    732

    Re: cnc router wont finish cut

    not sure what you mean, with a .080 bit i wouldnt think it would what motor i had would make a difference its so tiny. certainly doesnt need much power.
  6. Replies
    9
    Views
    732

    Re: cnc router wont finish cut

    3.5k on spindle and 450b on steppers. i did not notice any miss steps but im new but the machine did exactly the same thing on 8 cuts and all cuts look the same. the machine ramped out instead...
  7. Replies
    9
    Views
    732

    Re: cnc router wont finish cut

    thanks for the help, the machine seems very rigid, i tried looking up on the internet about overshooting with artcam pro and didnt find anything i will try tomorrow and slow it down and see if that...
  8. Replies
    0
    Views
    301

    cnc router wont finish cut

    i have a cnc router and i am cut thin plastic so i am running at 100" min the cut is good. when it goes to finish the circle the machine pulls out about 3/8" early leaving a gap of unfinished...
  9. Replies
    9
    Views
    732

    cnc router wont finish cut

    i have a cnc router and i am cut thin plastic so i am running at 100" min the cut is good. when it goes to finish the circle the machine pulls out about 3/8" early leaving a gap of unfinished...
  10. Replies
    0
    Views
    1,114

    the cutting of a vector wont connect

    i have artcam pro and am very new to this. i am cutting a ,080 slot .090 deep in expanded foam pvc i use 100" feed rate and it cuts good but where the tool enters and exits there is an incomplete...
Results 1 to 10 of 10