Search:

Steel is preferred

Two Piece Tooling Set
One or each
Steel, no finish
Plate could be aluminum

Please quote 4 pieces

DXF will be provided

No bending or finishing necessary

Thanks
Paul

Anyone know how to adjust EURAM tooling on a Baileigh press brake?

We are looking to hire someone ASAP

Paul

Please quote

1 piece
Any steel will do, but something prehard preferred

Paul
[email protected]

Please quote 6 pieces

Prefer prehard steel, but any decent grade of steel will do for prototype

paulcortina@yahoo,com

Does anyone here do wire bending?

About 3", .075 steel wire

Please quote 25 pieces

[email protected]

For the prototype. whatever you have available or cheapest

Thanks
Paul

Bore out hole in aluminum part

I piece

Sprocket mod

Please quote 3 pieces

I will supply sprockets

I'm still looking for a good quote

YES

Sprocket mod

Please quote 3 pieces

Please quote one piece of each.

Any machine part grade of steel will do for the prototype.

[email protected]

X

Mild steel or whatever non-stainless square stock you have around,

No finish
I have +/- .01 in the title block but +/- .02 would do

This is not a precision piece

I was thinking, lathe cut bar stock, but you could saw cut it I guess

I need 50 pieces of this steel square

Can anyone bang these out for a good price?

Mild steel or whatever non-stainless square stock you have around,

No finish

Break edges to match the...

I’m looking for a manufacturing partner for an automotive engine component, preferably someone with automotive aftermarket experience.

I invented a roller timing gear set and seek help with the...

Typo fixed. See new drawing. If you can't hold a tolerance, let me know. Most can be opened up.

Please quote steel stamping. Automotive aftermarket component.

1 piece (prototype)

50, 100, 500 peices

Stainless and or mild steel

I’m looking for a manufacturer for a plastic injection molded utility knife handle.
I may also do it in aluminum if price is right.
A shop with hand tool or construction/renovation equipment...

Good question.

Mine uses a conventional propeller rather than a hydrofoil.

There are numerous advantages to a conventional prop. That is why almost all boats use them.

Victor,

Your company sounds very interesting. Where are you located?


Paul

Can you tell me more about your company

Where are you located?

I invented a wave power device that drives a propeller and an alternator from the motion of ocean waves. The first prototype is complete.

Some of you have quoted parts for this.

At this point...

Modify two sprockets (add mounting holes and ID). I'll supply the blanks, they can be hard or soft. I would prefer cutting them hard to save time on heat treating.

[email protected]

I can get them hard or soft from mcmastercar.com or similar source. Heat treating cost should be included in the quote. The teeth are probably in the Rc50-60 range.

Please quote:

1 piece Stand
1 piece Adapter
2 pieces Mount
2 pieces Plate
2 pieces Sprocket mod (I will supply)

Thank you
Paul

These parts are hard so laser cutting will be required.

I will supply them. Two needed.

There are other (non-hard) parts needed for this project also.

Paul
[email protected]