My company has been using TopSolid for years and have typically saved the models to *.Top/*.Tp files. I have recently setup a new programming station and purchased the Biesseworks software/required...
Type: Posts; User: JohnFBiesse
My company has been using TopSolid for years and have typically saved the models to *.Top/*.Tp files. I have recently setup a new programming station and purchased the Biesseworks software/required...
Franklin Fixtures -- located in Cookeville, Tennessee -- produces shelving, display, counter systems, tables and specialty wood fixtures. Franklin Fixtures are known nationally as the highest...
I'm trying to meet some deadlines with this Rover35 EPS but I found out last night that the motor to the spindle chiller has seized. The machine doesn't throw itself into fault due to some wiring...
I have a Rover S1.30 and have recently bought new tool holders. We just recently purchased the machine and had to cycle/clean the electrospindle a bit to get it moving fluidly. Now, after installing...
Thanks to all of you for your replies. They were extremely helpful in finding what we needed. I ordered IMI Norgren 100200400 Pneufit 10 packs and they've worked perfectly. I am adding a picture for...
Thanks, I will try these out!
- - - Updated - - -
I have been looking at these unions but I am a little worried that they will not hold against the pressure of the grease line. The lines tend...
We have a Rover 35 EPS with the pneumatic auto-locating rails. This machine is beastly which in turn means there are a MILLION grease lines feeding through from under the rear 30 tool carousel. This...
Thanks! Now on to the next problem.
So you use multiple licenses? I have a tech offering to sell us a USB Dongle to use on the PC but we aren't really sure that it will be enough to get this biesse programming software running. He...
I guess I will continue waiting for a call back from Biesse but hopefully someone can offer some helpful information on this matter.
I am installing a new system on the shop floor for a secondary programmer. I have gotten all of the required software other than Biesseworks. I have 3 Biesse wood routers with editor on each and...
Have you tried an over-material rough cut, followed by a cleanup cut with a separate cutter? I use a 3/8 DS for most of my work followed by a 3/8 CS to trim 0.2mm- 3mm excess horizontal material and...
For more than 5 years, I have had 3 Biesse routers and one main programming station. I recently purchased a new PC and placed it in the shop to have a secondary programmer on the floor. Will I need...
When you create your toolpath, are you selecting the proper geometry identifier? If you have your created geometry identifier, it should be selected after creating the necessary toolpath. Should be a...