Search:

The problem was two-fold. The pump itself was frozen. I had to break it down to get it spinning again. On top of that, there was a breaker behind on the other side of the control box where that meter...

Hey everyone,

I have a Sodick A325 here in the shop that is having resistivity issues. Both the filters and the resin tank have been changed out, but the meter is still around 1 when the trigger...

Hello, we have an old Sodick A430L with a Mark Ex EDW control. We have had countless problems on the control side from bad boards to fire. Is there a way to replace or upgrade this control side to...

Hey all,

We have recently found that the paint in the cutting basin of our old Sodick is coming off resulting in some rusty areas. We've already started the process of dis-assembly and paint...

Hey everyone, I recently ran into some "fun" trying to do cardinal wedge cuts on a chrome coated cylinder. Long story short, I was over engineering it. But it got me wondering (after all the bric a...

Just to let everyone know, it turned out to be a ground wire that somehow came off the board directly behind the main breaker in the Control Unit. Once that was hooked back up and the associated...

This appears to be the case. I have disconnected the cables from the power supply and I still have a short circuit error. At least I can stop looking at the cutting basin and scratching my head. Any...

There is nothing that I can see. I've had another technician go over it too, so I don't think it's a visible problem unless we both missed it.

Hello everyone! We've been having a problem with our new old EDM for the past several days. Anytime we use a cut operation whether with or without water, the machine errors with a short circuit. I've...

We actually had that problem on our Sodick A320L with the Mark EX control. We had to send the computer in for repair. Something about a blown capacitor I believe.

Hello all! I am a technician with an FA lab located north of Houston. We recently acquired an old Sodick A320L to help us cut hard facings and acquire fine cuts. We've been having issue after issue...