509,639 active members
3,198 visitors online
Register for free
Login

Search:

Type: Posts; User: ashrafhosni

Search: Search took 0.00 seconds.

  1. I have same problem Could you help me to solve...

    I have same problem
    Could you help me to solve my problem
  2. I have same problem So Could you send me its...

    I have same problem
    So
    Could you send me its parameters and diagnosis
  3. Replies
    4
    Views
    104

    Re: Cincinnati milling machine

    thanks for your reply
    could you explain to me more about
    bad control power supply
    wait your reply
  4. Replies
    4
    Views
    104

    Re: Cincinnati milling machine

    thanks for your reply
    i will check and update you soon
  5. Replies
    0
    Views
    74

    emco concepet mill 300

    i have a problem
    when i press cycle start machine gives me alarm "door open"
    so i need its electrical manual
    if anyone have it
    send it to me
  6. Replies
    4
    Views
    104

    Cincinnati milling machine

    I have a problem in my Cincinnati milling machine
    That after it works
    It gave me "power supply fault"
    And machine is stopped
  7. Thread: need help

    by ashrafhosni
    Replies
    0
    Views
    57

    need help

    i have Chiron fz22w with Fanuc om

    i can't make home position
    when machine is powered on z,x,y axis is flicking, when i press in +z machine not run to reference and no error

    can any one help ...
  8. Replies
    4
    Views
    113

    Re: cincinnate milling machine

    i have solved my problem
    i found all spindle switches is cut-off and reconnect all again
    after that my machine is running in a good case
  9. Replies
    1
    Views
    98

    hi cell hitachi seki

    i have hi cell hitachi seki turning machine
    and it stored about three years

    when i connect it to power
    it gives me LSPC error and i replaced battery
    and after that

    alarm 1102 HSPC error...
  10. Replies
    4
    Views
    113

    Re: cincinnate milling machine

    thanks for your reply
    i'll check all limit switches (+X, -X, +Y, -Y, +Z, -Z)
  11. Replies
    4
    Views
    113

    cincinnate milling machine

    after machine alignment complete
    when i click start cycle for a program or MDI block
    machine doesn't work and give me a message
    " Axis Limits Off"

    could anyone help me for that
Results 1 to 11 of 11