Search:

I'm looking for someone in the USA who has removed and updated their OEM Sieg SX3 (1000 watt) spindle motor - I would like to build a mockup for the SX3 power boards and need a motor to make the...

This should get you in the ballpark - it is a 120 volt version but the wiring is pretty much the same.

http://littlemachineshop.com/reference/drawings/WiringDiagram2513.pdf

Your SCR's are...

I'm in completely over my head - I just want to do a simple spindle function test on some hardware I have on the bench, (SX3) <-> (XMT-SK) <-> (G540) <-> Mach3 Demo.

I have a PC running Win XP /...

Thanks for the reply ! You are correct that shipping would be a major issue and it would probably cost too much. Here in the US we have 'Flat Rate Boxes' for $20US that allow unlimited weights...

Had anyone else tried this ? I connected an SX3 powerboard to a SX2 motor. I can get it to run for a second or so, but then the motor over-speeds and shuts down. I thought perhaps the hall effect...

I made a breakout board to test the signals between the XMT-SK and the motor control board. The problem with the START/STOP function is a missing jumper (See attached photo) that must be installed on...

Here is a picture of the one I am evaluating. It wouldn't surprise me if there were 2 or more versions !313090

Interesting, very interesting. Does the start/stop issue exist when the interface is used with the SX2 as well ? Do any signals appear on the controller side of the interface board when the...

FWIW I'm in the middle of a project involving the aforementioned interface - The start/stop pin doesn't seem to be working correctly, and I'm waiting on a second board to compare readings. After...

I wish I did have official schematics - everything I have on the SX3 is reverse engineered - handwritten notes based on voltage/scope readings, etc. I think someone on this forum may have previously...

Thanks for the reply- I have already repaired the board I currently have, and am attempting to build a full mock-up so I can easily and quickly repair more of the SX3 boards. I already have a test...

I'm interested in speaking with someone who has successfully used a XMT-SK interface with an Gecko G540 to drive an SX3, The pinout for the XMT-SK is not well described in the documentation I have....

Yes, I do understand that the SX3 as well as the SC2 , SX2 and SC4 all use an Atmel chip acting as an encoder. What I am looking for is someone who has written code for the ATMEGA8 which would allow...

Has anyone in the group managed to write code for the Atmel chip in the SX3 that would allow step-by-step or some type of manual control of the motor drivers ? I am searching for something I could...

I would like to get my hands on a non-working Sieg BLDC controller. I currently repair the DC motor controllers and want to do a post-mortem on a BDLC controller so I can design a mockup to repair...

It's interesting reading - I'm beginning to think Sieg never released adjustment data for their boards. I think a little common sense listening to the machine motor may be the best way to adjust the...

I have just finished repairing a controller board for an X2 and I'm looking for adjustment procedures for the overload and speed control circuitry. I have the prints for the boards but no adjustment...