Our company has recently purchase an retrofitted Elgamill with a TNC 426 controller. They unable to assist further with using the 3+2 head rotation within the controller.
From my understanding we...
Type: Posts; User: Imjay
Our company has recently purchase an retrofitted Elgamill with a TNC 426 controller. They unable to assist further with using the 3+2 head rotation within the controller.
From my understanding we...
Just some final yes/no's before I don't do something ineffective against noise, would this layout render useless to shielding because of that piggy back wire to the GND point (as well as the soldered...
I meant glands as they would keep the shielding intact (rather than cutting and using a connector) and then being able to terminate in the ways you posted
So having the ground through a pin,...
Pretty exciting that I'm finally getting around to my mill conversion. I've been trying to read up on all the conventions about control panels by the majors but can't seem to tackle these.
Am...
That's what I'm looking for. Shielding with foil and braided copper.
The cable will be used for servo drives, no a VFD. So without in-depth electrical knowledge I'm going overkill trying to...
More suited to the buy/sell section, but would prefer Aussies to see this since I'm in Brisbane.
Just looking if anyone has some shielded cable suited for a vfd or servo drives.
If not, does...
Ello.
I got some fairly cheap CSMQ-04BH 400w servos, as well as some CSDj-04BX drives and I've only managed to find information on the drives (OEMax manual).
Currently in the process of...
Approx how many of each part?
I can ask for a rough quote tomorrow and forward you through if you like the price.
~ Jay.