Does anyone know how to connect to the Agie wire cut AC series machines (AC100, AC200 etc.) via the internal serial data port ? The 9 pin connector is clearly seen on the TR04B interface board and...
Type: Posts; User: Vector42
Does anyone know how to connect to the Agie wire cut AC series machines (AC100, AC200 etc.) via the internal serial data port ? The 9 pin connector is clearly seen on the TR04B interface board and...
Hi,
I have installed program but when I try to open a gerber file it gives message "Unhandled exception ... Object referenece not set to an instance of object". If it try to continue it just seems...
This is an associated question;
After an interruption such as an alarm or ES, when I hit the Start/Pause button the program starts over from the beginning. How do I get Camsoft to start where...
If the battery in your computer has failed you will have to replace it with a similar type. Mine had 2, one on one of the plug-in boards accessible from the back but another buried in the bowels of...
I have the same problem - I have a Howa lathe with Fanuc 5T controller and cannot get the first 3 parameters in.
I do not have the "magic" tape but will try with a file containing the code...
Thanks guys for the comments. To reply:
Del: Yes, I got a bit confused with the 2 types of delimiters. It has been a while since I worked on the machine. The microswitches are ramp actuated,...
I have an old Japax ELVY Wire EDM machine and I am having difficulty loading the operating system from the floppy disks. I think the disks are worn out and I need some help.
Does anyone have one...
Thanks Karl for your prompt response as usual. Sorry, I can't buy you a ticket to NZ, but you should come for a holiday !.
It is not my machine, I am just the poor sod that got the job. I...
Del,
Thanks, good suggestion. Here it is for Z. X and Y are similar. This is a copy from my home computer and I am not sure why there are semicolons where there should be commas but when I go...
Many thanks, Del, Karl and Al, I have had success.
It was not the hardware as in Z complement and my trying to use the AL was a red herring.
I tried part of Karl's code using the FI command...
Thanks Karl for that suggestion. I was hoping that someone had actually come across this problem and had a known solution.
I am not very familiar with using the native Galil commands but in the...
Help !
I have encountered a problem with my homing sequence for any of the 3 axes on my mill. The sequence searches for the home microswitch and then comes off that and searches for the index...
I have aquired a Cimnet BTR in good condition (I think it is actually new and unused - although old), but with no manual. Is there anyone here who has a manual in PDF or other electronic format...
To anyone following this thread - I have found the problem. The FC9801 does not appear to have a CMOS screen at all and just relies on the positions of a row of DIP switches. One of these (S2-5)...
Hi there,
I am new to CNC Zone so if I am in the wrong place please re-direct me.
I have obtained a Japax ELVY wire cut machine with a NEC FC9801 computer. The computer would not boot off the...