Search:

So after researching for awhile, I decided to go with Steppers after all, and also that my torque 'heavy' stepper motors were a bad idea. I read and read and read and came to the conclusion that low...

Thank you Craig, and Daz, i'm going to keep looking at the specs of the servos and what they need and the steppers before I spend any money, you've given me a lot of useful information.

I had not seen those videos, thank you for the links they're very helpful!

I'm reading up on the differences between the torque on the servos and the steppers and trying to decide if I want to afford the servos or not. I'm still trying to learn before I spend any money, I...

Hi folks;
I'm building (or retrofitting) a pretty heavy duty table i'm going to be using to cut 3/4" particle board with (Melamine). The table has a cutting area 4X8. I'm cutting cabinets out of...

Hi Folks;
I just bought my second router table, unfortunately someone's removed the nameplate and after searching for two days I can't figure out what brand it was originally. I'm going to be...

Just to finish this thread in case anybody else finds it down the road (nobody replied)..... new belts fixed this up and got it cutting very accurately. The spot where the belt was stretched in the...

I believe I found my problem. When I noticed the belts were sagging, I adjusted the motors by loosening them and pulling them tight, this tightened up the belts.... I did this in the middle of the...

Hi folks!
I've been 'tinkering' around with a Zenbot 4896 I bought a year or so ago and recently developed a problem I can't quite figure out and thought I'd run it by some people who undoubtedly...