Search:

Bob
Did the Charter oak mill tram up well.
If you answered this I apologize

Randall

Sorry Bob
Talking to trolls not you. You have posted some great info and I can't wait to one of these mills.
Randall

When you start off like that why dont you check it yourself. Since your information is limited don't knock it.
Randy

looked at your part. part of it can be done with lathe, looks lik there would be a mill used too. Is this a bolt carrier.
Randy

Your right, turned antivirus off but no effect. I had to uninstall it and get another. I thought that is what you you meant.. Its unsettling to uninstall antivirus without having another that will...

Sean
you figured it out in 2 or 3 questions, very nice. Thanks for your help.
Randy

Thanks for suggestions. Called today and finally tech new what it was. My antivirus was the Problem.
deleted installed a different one and I am happy now not to have to rely on laptop.
Randy

i HAVE DONE MOST OF WHAT YOU SUGGESTED WILL CHECK FILEPATH., OH EVERYTHING IS UP TO DATE BY THE THANKS FOR THINGS TO LOOK
Randall
PS sorry caps

I have already done compatability wizard with run as admin and different versions of windows, looks like its going to run than nothing.
I will have to call bobcad support. Runs great on my laptop...

Hey put me on the list for belt drive conversion,I am prepared to wait.
Randy

Bobcad 26
omission sorry
Randall

I have a dell a dell XPS 8700 I5 intel 8 gigs ram, with gtx 770 with 650 watt power supply on windows 7.
Bobcad would start one or two times with old video card but wont start now. everyhting...

SO where are the set screws and can you take them off without diasembling the gear box.
Randy

SO DAVE
do you sell these?
Randy

That looks great.
How does it sound.
Randall

I purchased one of these about 6 years ago. I retrofitted it with a hobbycnc board and new steppers and run Mach 3. I am very happy with the results.
Randy

sorry to jump in but I upgraded Preditor editor. does that get upraded by Bobcad and my license or some other way
Randall

Man looking good.
Randy

What size steppers are you running. That's blazing fast. I have not noticed any movement in X motor mount.
Randall

I have upgraded my X Y axis and lead screws and tuned it 120inch per minute rapids just until I reinstall limit switches. I have 200ounce inch steppers times 4 is 800oz inch. I don't understand the...

I deautheorized and reinstalled software and my problems went away.
Randy

I started having a problem with drill. I select geometry and bobcad crashes. I called tech support and after trying a couple things tried to get next tier support on phone, couldn't then said I had...

Nice Job
That helps me alot.
Thanks
Randy

Thanks for posting Engine guy
Now I just gotta wrap my head around it and hope original poster replies.
Randy

Are not rear tool posts tools mounted upside down so you dont have to reverse spindle???
Randy

Me neither lol
As that rear tool post moves to stock x is getting larger ror is it a -x that gets smaller, if the later just put rear tool path in -x -Z quadrant and select the correct tool...

I am no expert but does rear post us -X moves?
if so then put rear tool post bath opposite x quadrant.
Randy

Please keep posting. Wonderfully work.
Randall

I had this problem and picking a different post processor fixed it. there are several post procesors for Mach choose a diferent one and see if that helps.
Good Luck
Randy

I've played with turning a bit and watched the tutorial, in that tutorial they placed the tool path in upper left guadrant so Z 0 is the start of your part and x toolpath is positive, have you...