Search:

I'm out of town at one of my works other locations doing a realignment on a 2016 chc st30y after a crash. Everything is back to spec and I left the spindle centerline to tool pocket for last. No...

After sitting for 3 years I finally got my powerpath under power. Had to do the single board computer upgrade and new hard drive. It comes up and homes. The hydraulic motor and pump sound fine but...

thanks ill read up on it when i get a min. the way the tech at shop floor talked if it will only dnc from ezlink ill need a computer out at the machine and no pendant. but if it will xon/off the...

ya the manual is very vague on the dnc topic.
VMC Operator's manual mentions it only 3 times.
page 1-1 "DNC data transfer between the pc based front end and the cnc machine controller which...

thanks your first sentence is my main question. does anyone with my dx32 control DNC via the rs232 with xonxoff.

thank you for the reply.
I'm hoping to not place a computer at the machine. id like to be able to stick the usb in at the control. so I'm hoping something like calmotion or shop floor automation is...

Does anyone use the shop floor automations usb connect pendant https://www.shopfloorautomations.com/hardware/pendant-usb-connect/ for DNC

i have a 1997 vmc 800 with dx32 control. I installed a...

hello, would anyone have a copy of the back up for a power path 15.
mine is corrupt.

thank you.

I got two of the 800's. were you looking at the machines in Lewiston?

Hello, I'm looking at purchasing one of the following Bridgeport's.
I'm looking to put one in my home shop mostly aluminum parts.
If you had your choice, what would you go for first? Should I...