Search:

Not knowing your machine it looks like your feed rate is too low, which gives you a low chip load. Are you running a spindle or router?

I've been a big fan of MariTool https://www.maritool.com/ER-Collets. I run their ER25 collets with my 2.2kw Chinese spindle.

At the Thermoforming company I work for we switched over to their blades about 10 months ago. So far they have worked great. Their turnaround time for orders has been quick. We are using them on...

Nice work. Looks like a good build.

CNCMAN172 - from my testing Mach4 is no better at 3D files than Mach3. It is my understanding the trajectory planner is the same as Mach3.

Yes the MB2 board has some very nice specs. It has a...

Great info Gerry. Thanks for the link.

Nice rendering Gerry, really like your planned setup with this pair. Sounds like the MB2 is a good match for the UC300ETH. Looking forward to how it preforms on a machine.

One of the things I'm...

Here is a little background. I currently run a CS Labs CSMIO/IP-S with Mach 3 on my main CNC Router. I've been very happy with the IP-S but not so much with Mach 3. I have tried Mach 4 on this...

I thought of that just after I sent my last post.

Any tips for tuning the main settings?

James do you have a link to your kit?

Received some good info from DMM. Still looking at other options but they may be the route to go. I just need to find replacement timing pulley's, as my current ones are for .5" shaft dia.

That's good. How easy are they to tune? I have zero experience tuning a servo.
Yea I would love to go with Yaskawa but last I looked it was about $2k for Motor / Driver set.

I sent an email with a few questions off to DMM Tech lets see how they respond.

CURVEDMTL - Thanks for the info. I have seen Camtronics page before. Unfortunately their servo setup is not quite...

mactec54

Thanks I'll check them out. Do you have any experience with them?

I'm looking for some recommendations for servo motors & drivers. Wanting to upgrade my Nema34 steppers on my CNC Router. I was looking at the Teknic ClearPath SD series but unfortunately my...

Thanks everyone for help. I chose to go with the CS Labs CSMIO/IP-S. Its on order, now just waiting for it to arrive.

Gerry,
Thanks for the info.

Euge3000 - Thanks for the info. Do you have a link to your google plus videos?

Hi all,

Looking for a recommendation on a motion controller. I'm planning to changing a Mach 3 controlled 4'x4' cnc router to better electronics. I was looking at the HiCON Integra or CS Labs...

We have a older Techno LC4848 CNC, currently the Router / Spindle is turned on/off manually at the start/end of each cycle. Since we use it to trim plastic parts that can be upwards of 20 times an...