584,862 active members*
5,708 visitors online*
Register for free
Login

Search:

Type: Posts; User: joseph10s

Search: Search took 0.00 seconds.

  1. Replies
    4
    Views
    1,924

    Hi Jesse, Would you mind elaborating on the...

    Hi Jesse,

    Would you mind elaborating on the repair? I am having a similar problem with an SKT21-LMS. M5 does not stop spindle and AL-15 SPINDLE COMMAND TIME OVER during a run.

    Thanks,
    Joseph
  2. Replies
    9
    Views
    2,871

    Mike, I honestly don't remember exactly what I...

    Mike,

    I honestly don't remember exactly what I did to clear this alarm. My situation was a little different in that the pin that locks the turret into position was engaged in between two turret...
  3. Replies
    9
    Views
    2,871

    thanks for the reply, Maz. Its a fanuc oi-tc...

    thanks for the reply, Maz. Its a fanuc oi-tc controller. I am unable to move anything because i get a AL-64 TURRET INDEX TIME OVER error when the machine starts up from power off. I cannot run the...
  4. Replies
    9
    Views
    2,871

    Machine Frozen

    Help needed. I get the error message AL-64 TURRET INDEX TIME OVER when I start my Hyundai Kia skt 12lms. I bumped the turret into the main spindle while doing a tool change. The turret is stuck...
  5. Replies
    0
    Views
    898

    Tool Post Home Position

    Hello,

    I bumped my tool post (turret) during a tool change last week. It was the end of the day so didn't want to deal with it at the time and shut down the machine. Today when I powered up the...
  6. Help Needed: Lathe live tool milling Cutter comp.

    I am working on a Hyundai Kia SKT 21LMS with Fanuc oi-TC controller. I am attempting to mill a 1/4" hex on the face of a 3/8" SS rod. My initial efforts have lead me to the following code which...
  7. Replies
    11
    Views
    1,624

    Thanks, Al. The unit runs pretty much nonstop,...

    Thanks, Al. The unit runs pretty much nonstop, 24/7. No way to use a small DC computer fan? The reason I ask is because I see a +10V output terminal on the VFD.

    Joseph
  8. Replies
    11
    Views
    1,624

    Thanks for all the help jschmitt. A couple...

    Thanks for all the help jschmitt.

    A couple more questions. I am going to put this in a separate NEMA enclosure. Will i need to put a fan in the enclosure? Will two vents work? If I need a...
  9. Replies
    11
    Views
    1,624

    Thank you for your comments, Matt and Albert. ...

    Thank you for your comments, Matt and Albert. The one you found, Matt, was about $30 cheaper than the cheapest I had found.

    Next question, where does it get hooked up? The current...
  10. Replies
    11
    Views
    1,624

    3-phase motor Speed Control

    I have a chip conveyor on my Hyundai-Kia Turning Center and I would like to adjust the speed of the conveyor to limit coolant loss. The motor is a 3-phase induction 240V 1.0A. Does anyone know of...
Results 1 to 10 of 10