Trying to work to a model that is showing an 82 deg countersink with a diameter of .224". The material is only .035" think and the thru hole is modeled at .164". I'm being told it's impossible to...
Search:
Type: Posts; User: kperk12345
Search: Search took 0.00 seconds.
-
01-22-2018, 08:19 PM
Thread: Countersink too deep?
by kperk12345- Replies
- 2
- Views
- 424
Countersink too deep?
-
09-12-2007, 10:44 PM
Thread: How to - cutting lathe soft jaws?
by kperk12345- Replies
- 13
- Views
- 4,016
holding bar stock
Do you have any other options? Maybe a set of hardened serrated jaws? You don't have to be right on the 2.5 dia to hold it with serrated. Good investment if you don't have any available. It'll will...
-
09-05-2007, 11:55 PM
Thread: turning 304!?
by kperk12345- Replies
- 3
- Views
- 1,152
turning 304!?
insert choice?
about an inch long cut at 5.5" diameter, need to hold a 16 micro finish
speeds and feeds would be helpful too...
Thanks!! ahead of time -
09-04-2007, 11:54 PM
Thread: Help Program / Alarm
by kperk12345- Replies
- 3
- Views
- 807
Help Program / Alarm
It's an Okuma OSP-E100L control
code:
G0 X20 Z20
G50 S900
T0202 G96 S200 M3 M8
X3.8 Z.1
Z-.2
G1 X3.7614 Z-3151 F.02 -
09-04-2007, 11:49 PM
Thread: Lathe program/alarm issue
by kperk12345- Replies
- 6
- Views
- 2,212
Lathe program/alarm issue
It's an Okuma OSP-E100L control
code:
G0 X20 Z20
G50 S900
T0202 G96 S200 M3 M8
X3.8 Z.1
Z-.2
G1 X3.7614 Z-3151 F.02 -
08-02-2007, 10:07 PM
Thread: How to correctly chamfer a hole?
by kperk12345- Replies
- 42
- Views
- 9,748
umm just keep you're way lube full...
umm just keep you're way lube full...
-
08-02-2007, 09:40 PM
- Replies
- 33
- Views
- 6,360
with chamfers I just use tnr error =...
with chamfers I just use tnr error = tnr(1-tan(ang/2))
Results 1 to 7 of 7
