584,805 active members*
4,956 visitors online*
Register for free
Login

Search:

Type: Posts; User: ClintonBrits

Search: Search took 0.00 seconds.

  1. Replies
    2
    Views
    1,260

    Ah. Another homer simpson moment. It goes to a...

    Ah. Another homer simpson moment. It goes to a negative because the software is using a cutting to that goes half a tool length beyond the design border to cut the board size you specified. Thanks...
  2. Replies
    2
    Views
    1,260

    gcode ripper not starting at origin

    I am attempting a pcb with cnc router. All is set up and after crashing my bit and breaking it, i set up the design size 2mm smaller for tolerence. When i run gcode ripper however it probes the...
  3. Replies
    6
    Views
    4,603

    Thanks mate that helps clear up a lot of "what...

    Thanks mate that helps clear up a lot of "what if" scenarios we were looking at. My main concern was good isolation of my paths and and so i used large clearances on my circuit design assuming the...
  4. Replies
    6
    Views
    4,603

    I'm a major newbie with this. I asaumed the...

    I'm a major newbie with this. I asaumed the cutting depth meant how far my 30 degree 0.3mm tip went into the surface. The way to look at it is to assume that it is a 0 mm tip and work the diameter...
  5. Replies
    6
    Views
    4,603

    coppercam calculations on conical tools

    Hi.

    Im working towards getting a cnc machine to prototype boards.

    Ive managed to design it. Export to gerber and get it into copper cam. After going through all the forums and articles it...
Results 1 to 5 of 5