Search:

Hi, Are you referring to the SmartCam Manuals or the Mach3.
I meant if you have a programming manual for the mach 3 I may be able to get a code generator going.
I have been using Smartcam for quite...

Hi,
Do you have a programming manual with code examples???

Hi George,
Thanks for the info.
I did check the motor current (static) and set all axis to spec on the ACC board.
The voltage on the DC side drops about 2V when in rapid.
On a failure it never...

I have a Boss 6 series I machine.
I would like to know if anyone knows the correct dip switch positions on the ZCK board.
I have part of a manual and it describes the alignment procedure for this...

Hi Everybody,
Does anyone use Smartcam Freeform???
The question I have is when you create curves from polylines after doing a roughing routine it seems to leave some of the polylines intact instead...

Has anyone successfully used the ball screw compensation table in the Centurion IV.
I did the calibration and entered the numbers into the table.
The only effect it has is when you move the machine...

Does anyone have a G Post and FIL file for the Anilam 3000 conversational controller?
Any help would be much appreciated.

Thanks,

Ed

edsgarage is online now

Join Date: Feb 2008
Location: usa
Posts: 2
edsgarage is on a distinguished road
Hi Larry,
First, if you are using RS232 there are settings you need to set.
The...

Hi Larry,
First, if you are using RS232 there are settings you need to set.
The baud rate on the machine must be set to the rate on the communication software.
Windows had hyperterminal (The pgm...

Being that this is my first post I would like to say hello to everyone!!!!
This site is invaluable to anyone in the cnc world.
I have an arrow 750 with an a2100 control.
2 months ago the RT board...