I was looking for a 60w, but found a place called Bell Laser that sells the DC ps, wiring harness, laser tube, electronics connection, mounting brackets. for $3900 for a 50w
Type: Posts; User: closeracing
I was looking for a 60w, but found a place called Bell Laser that sells the DC ps, wiring harness, laser tube, electronics connection, mounting brackets. for $3900 for a 50w
60w max is all I need. I've seen used Synrad RF tubes with a power supply, but they were around $5000-$6000. Do you know a good supplier for the RF conversion? My controller has an output for RF...
So the answer is no.
Is there a power supply and glass tube combination that is capable of top quality photo engraving at speeds up to 300 mm sec? I recently was told the chinese c02 laser power supplies cannot switch on...
I did an image of early 1900's NY that was 53.5"X23.5" and a sign that was 48"X48". Both files were 300 DPI so the interval is .0847.
I also tried 254 dpi with the interval at .1 which did not work...
It's been an ongoing problem. The work area is 1300mm x 1800mm. I bought this laser so I could do large projects. Some of the files are over 100mb. The PC is set to never go to sleep so that is not...
Yes, it is hooked directly to a PC via Ethernet cable
Has anyone here converted their Chinese laser to something like wincnc?
I need to do large projects in high resolution and Ruida has said their controllers cannot process very large files (100mb +)
Hmmm. Thank you for your input. The machine is supposed to be brand new, It uses rubber bands for clamps and they are not super tight, possibly a used tube in a new machine or just a bad tube....
Ok I spent all day yesterday perfectly aligning the mirrors and troubleshooting laser tube. The beam on mirror 3 was not dead center when at the closest point to mirror 2 (though very close). Now all...
I load files directly from the computer via a cable. Is there a way to check the controller?
Thank you very much fir taking the time to help me out btw. This was a big investment and an even bigger...
The files look pretty good when I reverse them and engrave wood.
It will even do a decent photonegative on granite that way. The only trouble I've had with the controller is with an extremely large...
I have tried speeds between 100 and 400 mm sec, power from 16 to 54% and everywhere in between. You are correct, I was referring to dark gray areas where the laser should be firing but is not. Last...
Hello everyone, I purchased a machine from Unichcnc with a Ruida RD6442S control system + software for a monument business. The trouble I am having is that dark areas are not visible in the engraved...
Are the prerequisites described for an engraveable image a limitation of most Chinese lasers? I've seen some very good engravings from poor quality facebook photos.
Can anyone tell me how to get rid of these lines? I am now using Corel photo and RDworksv8. Resolution is 1500, frequency is 70 lines per inch,net graphic dithering. I've been struggling with image...
What controller do you have? If it's an RDworks controller lookup download rdworksv8 and you can download it free
Turns out there is a file size limit. My file was 102mb I had to make it smaller and it worked out
Hello everyone. I am brand new to the group and recently purchased a 60w Unich 1318 cnc laser. I am having a few problems that I can't seem to figure out.
The first problem is that the lighter areas...