Search:

Dear all,
i need for someone help in order to reload step-by step the memory of the CNC.
I have disk backup but i need to knoe the proceure.
Someone can halp me?
Thank you

Roberto

Option bit is already set.
So please check parameter
40#3 normally 0
219 (normally 30)

in this case M02 or M30 will increas the counter.
If parameter 219 is set 87 (example) then use M87 for...

You must set some Data (PC-PRM) to activate Turret Adjust Mode (please find them in the Ladder Diagram manual).
This Data are different from machine model to another.
Data are "double paramenter"...

Hi.
Go to System, and proceed with right soft key until you can see ETH-PRM
There you have to set IP address, Port number etc etc,....
After that check the comunication, using PING comand from PC...

i tryed to do so, but it says that install file not present.
If i try to read disk#1 #2 in my PC they look unformatted.....is it correct?

Try to format it using boot service mode.
Then select i/o param=4
Then try again

Roberto

Lathe machine LCS15E with OSP7000 has lost datas due to battery backup drop off.
At power on alarm 945 appear.
If i turn on maintenance switch on CNC i can see the menu to reload software data.
I...